Can axles be shortened?

If all four bearings are not aligned, shortened axle and carrier bearing life is almost guaranteed! Even if you are simply cutting down the original housing and axles, remember the horsepower they were designed to withstand and the tiny tires they originally used.

Can you weld axle shafts?

Friction welding provides a high-strength, cost-effective solution to join axle shaft sections or an axle to a hub. The result is complete metal fusion without the need for fluxes, fillers, gasses, or an external heat source.

Can I cut my axles to 9 inch?

When cutting axles to desired lengths, it is recommended that the following procedures are performed: To ensure you get the most out of your new 9 Inch components, it is recommended that you perform a proper break-in process:

What is the difference between 31 and 35 spline axles?

28 and 31 Spline Long axle is 33″ from face of axle flange to the tip of the splined end with 9-1/4″ of spline. 35 Spline Long axle is 31.75″ from face of axle flange to the tip of the splined end with 8″ of spline.

Should I install the driver’s side axle before the passenger axle?

When installing new axles in rearends with posi traction differentials, be sure to install the driver’s side axle first to keep the splines properly aligned. Failure to do so may move the two splined gears out of alignment, and it may be difficult to install the driver’s side axle properly if the passenger side axle is already installed.

How many people does it take to install the axles?

If installation of passenger side axle is done first it may require two people when installing the driver’s side axle, with both parties rotating reach axle until splines are in line and the driver’s side axle fully sides into the housing. When cutting axles to desired lengths, it is recommended that the following procedures are performed: