How do you troubleshoot a roper washing machine?
When you have problems starting the washer, check that the circuit breaker hasn’t tripped and that the timer is properly set, then pull the knob to start. If nothing happens, make sure the water is turned on. If it is on, turn it off and remove the hoses to check the inlet valves for debris blocking the water flow.
Do they still make Roper refrigerators?
Roper Brand Appliances Roper® appliances are proudly sold exclusively at Lowe’s. If you have a comment or question about Roper® appliances, please contact our Owner Support team.
Where is the model number on a Roper?
Located above the rear of the wash basket. This should be visible once you open the lid.
Is there a reset button on a Roper washer?
If your Roper washing machine is stuck in a cycle or will not turn on or off, there is a quick way that you can reset it. Locate the lid lock switch which can be found on the underside of the washer’s top panel. Lift the lid at least 2 inches and lower it. Do this six times within 12 seconds.
How good are Roper appliances?
Performance. The Roper’s Heavy cycle did the best with cleaning overall, though it lasted 90 minutes. It also retained 75% of the water in the clothes. The Delicates cycle, which uses a slower spin, left behind 97.5% of the water, and worse, the Casual cycle left 101% of the rinse water in the laundry.
Where is Roper appliances made?
Georgia
Roper Corporation, a subsidiary of GE Appliances, a Haier company, embraces this mission and during the pandemic, continues to supply the country with major cooking appliances manufactured at its Walker County, Georgia plant.
How do I find out how old my dryer is?
To find the age of your appliance, use your serial number, not the model number. There are two letters followed by six numbers in our serial numbers. The first two letters of the serial number tell you when it was made.
Why does my Roper washer won’t spin?
Common solutions for: Roper Washer won’t spin or agitate. Inspect the drive belt to determine if it is broken or if it is loose on the pulleys. If the drive belt is broken or loose, replace it. If the washer is overloaded, the motor coupling will fail in order to protect both the motor and transmission.